Nitecore ULM10 charger

[Schittra]

Advertisement (gone after registration)

I use nitecore charger ULM10 pro without QC2.0. So it won’t give me reach 1200 mA, right? 

When it shows as FULL, it is around 85% when I put to the camera. Do I understand correctly?

Hmmm... I think I will get the QC2.0 adapter then. 

Thank you for the input. 

[jakontil]

Even without the QC, it would still give you a real 1200mah capacity but slower and if you charge 2 batteries at the same time, it does simultaneously instead 

 

get the proper quick charger for nitecore

[Schittra]

26 minutes ago, jakontil said:

Even without the QC, it would still give you a real 1200mah capacity but slower and if you charge 2 batteries at the same time, it does simultaneously instead 

 

get the proper quick charger for nitecore

Thanks. When it reaches to 800mAh, it shows FULL.

[jakontil]

3 hours ago, Schittra said:

Thanks. When it reaches to 800mAh, it shows FULL.

Hi, what charger are you using? 
 

may b try to get the proper one

 

hopes it helps

[Soden]

I find with My ULM10 that if I take the battery out soon after it says full I get 1200Ah. However if I just let it sit for a while the battery drains to about 800Ah. It does not matter if I use my iPhone converter or my QC3

[LeicaS2]

Even if I leave the battery at the charger, I back it off the connection once I remove the power, otherwise I worried the battery would back drain into the charger.