tedsiciliano Posted September 20, 2015 Share #1 Posted September 20, 2015 Advertisement (gone after registration) Hello I am looking at getting my first leica! I am looking at getting a m6 classic I just have a few questions. I wear glasses and I hear that people who wear glasses should get a .58 magnification is this true? Would I be fine with .72 magnification? Another question is are the m6 classics as reliable as people say they are and how much money should I set aside for a service? Also what should I look over when looking at a m6? Thank you so much for help I appreciate it! This is the one I am looking at http://philadelphia....5216118730.html Link to post Share on other sites More sharing options...
Advertisement Posted September 20, 2015 Posted September 20, 2015 Hi tedsiciliano, Take a look here First leica!. I'm sure you'll find what you were looking for!
spydrxx Posted September 20, 2015 Share #2 Posted September 20, 2015 This link is a good start http://www.l-camera-forum.com/topic/249420-planning-to-purchase-an-m6-checklist/ as well as the info Gus Lazzari gave you on the pnet forum - Gus is a noted Leica repairman. Link to post Share on other sites More sharing options...
Trivette Posted September 20, 2015 Share #3 Posted September 20, 2015 I've had my M6 classic since around 1998, and it has not yet required any service. Last time I checked (a couple of years ago), a CLA was around $250. With reasonable care, there's not much that can go wrong with the M6. The meter, being electronic, may be the most vulnerable part, but even if it goes, the M6 just reverts to being basically an M4. Link to post Share on other sites More sharing options...
250swb Posted September 20, 2015 Share #4 Posted September 20, 2015 The camera in the link seems OK, some paint bubbling on the rear door by the looks of it, so you should check for any bubbling under the black chrome on the top and bottom plates as well, both cosmetic but could drive the price down in negotiations. The price is about right for a very good quality camera (no bubbling), but I wouldn't put any money aside for a service, it shouldn't need a service, and that is the advantage of buying from a dealer who can give a six month warranty. So don't be fooled by sellers claiming it's an old camera so it will need a service, they are really saying 'I haven't had any faults rectified'. Steve Link to post Share on other sites More sharing options...
glyn.evans Posted September 20, 2015 Share #5 Posted September 20, 2015 I have an M6 with .72 finder, and where glasses. The only issue I have with the .72, is that I struggle to see the 35 and 28 frame lines. Link to post Share on other sites More sharing options...
Trivette Posted September 20, 2015 Share #6 Posted September 20, 2015 There are a few tiny, almost imperceptible pimples in the top plate around the shutter speed dial on my M6, but it has been that way since I bought it. Anyhow, it doesn't affect the function of the camera in any way. Link to post Share on other sites More sharing options...
Doc Henry Posted September 20, 2015 Share #7 Posted September 20, 2015 Advertisement (gone after registration) It's not a TTL , if you use a flash one day. Rg Henry Link to post Share on other sites More sharing options...
tedsiciliano Posted September 20, 2015 Author Share #8 Posted September 20, 2015 I've had my M6 classic since around 1998, and it has not yet required any service. Last time I checked (a couple of years ago), a CLA was around $250. With reasonable care, there's not much that can go wrong with the M6. The meter, being electronic, may be the most vulnerable part, but even if it goes, the M6 just reverts to being basically an M4. since you have owned the camera have you gotten a cla on it? Are there any signs a camera is in need of a cla? Link to post Share on other sites More sharing options...
TomB_tx Posted September 20, 2015 Share #9 Posted September 20, 2015 I bought my M6 new in 1985, and by about 2000 it sat unused for a few years. I had left the battery in it, which leaked and caused problems to both the meter and the shutter (curtain brake). The shutter issue caused a light leak that would fog the last shot if left before advancing the film. Such problems are hard to detect without some extended use. The usual signs of issues needing a CLA are uneven exposure across the frame at high shutter speeds, and incorrect speeds (either too slow or too fast). Except for shooting and processing some test rolls this is hard to detect, unless you have a shop with a shutter tester for film cameras, or have an old analog (CRT) television to use for a visual check looking at the screen through the shutter (the TV shutter test you can find described by web search). With experience the sound of the shutter at various speeds can tell some issues. Link to post Share on other sites More sharing options...
too old to care Posted September 20, 2015 Share #10 Posted September 20, 2015 It looks like a nice camera. I bought my M6TTL new in 98 or 99, it has never had, or needed a service. Mine is a .85 and I also wear glasses. I only use a 50mm lens and have no problem seeing the frame lines, but I can imagine any of a wider lens would give me a problem. I think you will be happy with this one too. Link to post Share on other sites More sharing options...
earleygallery Posted September 20, 2015 Share #11 Posted September 20, 2015 I always tell newcomers, buy your first Leica from a dealer who gives at least 6 months warranty. I gave this advice to someone on the forums recently. They didn't listen and as a result their first experience of using Leica is a spoilt roll of film and searching for someone who can fix their light leak issue! The M is a simple camera but it's also prone to a number of quirky issues which seem to manifest themselves if not used regularly - at least a dealer should sell you a camera that has been checked over, and if there is a fault it will be resolved at no cost to you. The M6 you're looking at looks a clean one, apart from the rear door corrosion, but it's over priced IMHO, especially when you consider you have no warranty and you're buying a camera which you're not familiar with so might be buying someone else's problem. Link to post Share on other sites More sharing options...
tedsiciliano Posted September 20, 2015 Author Share #12 Posted September 20, 2015 I always tell newcomers, buy your first Leica from a dealer who gives at least 6 I gave this advice to someone on the forums recently. They didn't listen and as a result their first experience of using Leica is a spoilt roll of film and searching for someone who can fix their light leak issue! The M is a simple camera but it's also prone to a number of quirky issues which seem to manifest themselves if not used regularly - at least a dealer should sell you a camera that has been checked over, and if there is a fault it will be resolved at no cost to you. The M6 you're looking at looks a clean one, apart from the rear door corrosion, but it's over priced IMHO, especially when you consider you have no warranty and you're buying a camera which you're not familiar with so might be buying someone else's problem. can you recommend a leica dealer I live in nj Link to post Share on other sites More sharing options...
piblondin Posted September 20, 2015 Share #13 Posted September 20, 2015 can you recommend a leica dealer I live in nj Bergen County Camera. Link to post Share on other sites More sharing options...
tedsiciliano Posted September 21, 2015 Author Share #14 Posted September 21, 2015 Any other ones? I would be fine with going to philly also? Link to post Share on other sites More sharing options...
pinchers of peril Posted September 21, 2015 Share #15 Posted September 21, 2015 The price seems reasonable since it includes the grip, but I agree the slight bit of visible bubbling may give you some room for negotiating. I wear glasses and I found I could see the 35mm framelines on my .72 with a little bit of hunting around the edge. The 28mm framelines were basically impossible for me to reasonably see. I only have one lens at the time and it is a 50mm so I actually ended up buying the Leica 1.25x magnifier and that works perfect for the 50mm framelines. I know some people who automatically send these in for CLA even before they've tested it. This seems silly to me. If you end up buying it I would just start shooting and then look at your film to see if there are any light leak issues or anything. I probably wouldn't send it in for CLA unless you find a problem. I think the most common things to go wrong with these older M's are the slow shutter speeds (which often you can diagnosis by just listening). Link to post Share on other sites More sharing options...
tedsiciliano Posted September 21, 2015 Author Share #16 Posted September 21, 2015 Another one I found for close to the same price http://www.collectcamera.com/products/object_details.php?object_ID=3682&ocat_ID=1&ocat_ID2=&pos=&action=&act=search&search=ob3682&lang=eng Does anybody know anything about this website? I am willing to pay $100 for piece of mind but if this guy isn't reputable or it is too much to ship I'll stick to the one on craigslist Link to post Share on other sites More sharing options...
tedsiciliano Posted September 21, 2015 Author Share #17 Posted September 21, 2015 I also found one on adorama with an e- grading what grade would you give the craigslist one based on the adorama scale. What option between the 3 m6s I have found would you pick? Link to post Share on other sites More sharing options...
earleygallery Posted September 21, 2015 Share #18 Posted September 21, 2015 There's a list of all official Leica dealers on their website - probably worth starting there. I'm sure you'll find a good M6 with warranty close to home. Link to post Share on other sites More sharing options...
Herr Barnack Posted September 21, 2015 Share #19 Posted September 21, 2015 My first M camera was a 2003 MP with a 0.72 viewfinder. Although I wear glasses, the 0.72 viewfinder was not that much of a problem, especially with a 50mm or longer lens. A 28mm lens was a bit of an issue, but was nothing I could not live with and get accustomed to. If you buy an M6 with 0.72 magnification and discover that it just doesn't work for you, Sherry Krauter can easily install a 0.58 viewfinder. Link to post Share on other sites More sharing options...
250swb Posted September 21, 2015 Share #20 Posted September 21, 2015 Same as above, my MP has a .72 finder and I wear glasses, and I adapt. I'm not saying you can see all the 28mm frameline in one go all the time (unless pressing my glasses very hard into the finder window) but you can learn to see around the viewfinder with a quick rotation of the eye to see the edge frames, and you do learn to anticipate a slightly wider view than you can physically see. I have had a .58 finder camera and I wouldn't go back to that even as a glasses wearer, everything looks like a pea on a plate and not nice. Steve Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.