Jump to content

Press shutter release nothing happens


Guest NEIL-D-WILLIAMS

Recommended Posts

Guest NEIL-D-WILLIAMS

My new 007 worked flawlessly on my last trip. There were s few ovations when the shutter wouldn't fire but that was because there was a picture still on the LCD for viewing. Once the picture was removed all worked normal again

Link to post
Share on other sites

I've had this issue on my S2-P for three years now with the camera in AF and focus/recompose. It helps to quickly focus on something else and try again. My impression is that the problem occurs when my finger slightly loosens up while recomposing, after wich the camera thinks it hasn't archieved focus and blocks the release.

 

For me, it's just one of the quirks I have to live with and luckily, my photography does not need exact timing.

Link to post
Share on other sites

The last time I had my S2 in Wetzlar for a complete checkup, I talked with the tech about this issue.

It neither could be replicated nor could anything about the camera body be found out of spec.

 

I still remember this very same issue happening back with Leica M9 bodies and MM bodies (both models I have used and also experienced this issue).

 

It happens very, very rarely with the S2 (I cannot remember when it happened the last time with mine but it was some long time before the last service).

When it happens (when anything weird happens with a digital Leica ), I am conditioned to simply:

 

- switch camera OFF
- drop battery
- reinsert battery
- switch camera ON
- re-check camera settings
- continue shooting
 
With the S2 I like to do the lens reset in a similar fashion if something acts up too (just unmount / remount the lens).
 
I never had any camera stuck after such a battery drop neither my own S2 when this happened nor loaners.
Link to post
Share on other sites

See this post:

http://www.l-camera-forum.com/topic/260344-delay-in-shutter-release-in-the-high-north/?p=3046890

I think the problem has been pin-pointed, but not solved, would probably require a FW update for S2/S006

Thank you for the link.

 

If you are talking about the GPS problem, than the S2 has none, at least the last time I looked at my S2 , it had nothing of that kind inside or outside, no GPS nor Glonass.

 

Not very often, several times this year, my S2 did not fire up and I cannot see any pattern. It just happens. I remove the battery and replace it. It has been a problem for years. A bit annoying, to be honest.

 

 

 

 

Sent from my iPad using Tapatalk

Link to post
Share on other sites

Thank you for the link.

 

If you are talking about the GPS problem, than the S2 has none, at least the last time I looked at my S2 , it had nothing of that kind inside or outside, no GPS nor Glonass.

 

Not very often, several times this year, my S2 did not fire up and I cannot see any pattern. It just happens. I remove the battery and replace it. It has been a problem for years. A bit annoying, to be honest.

 

 

 

 

Sent from my iPad using Tapatalk

 

 

Maybe the firmware is looking for it ? ;-)

You are of course right. I never experienced this problem om the S2, but frequently on the S006, and I live in Norway, so the explanation was plausible to be, but it is hard to isolate the problem.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...