Search the Community
Showing results for tags 'blurry film'.
-
Hi everyone, I'm a new Leica user and bought an M6 Classic with a Leitz Summicron 2.0. The first roll came back blurry and I thought it was my shooting..then the second and third and so on. I sent my lens in to Keh (where I had gotten it) to be serviced and it came back with the same results. The images are generally overexposed when in very sunny conditions and all of them are very softly focused. I shot most of a roll at f16 and not one thing was in focus. I don't think it could be the lens, as it just came back from being properly adjusted so I'm wondering if it could be the body? I'm not sure what to do as I've spent my budget on this setup. I was going to send it in to get the VF upgrade because I was experiencing some flaring but that is not what is happening here. Any tips very much appreciated.
-
Good Afternoon, I'm not at my computer now so it wont be later until I post some samples of the problem I'm describing. Revisiting film, I've developed two rolls of Delta 100 using Illford chemicals to box specs. When I scan the negs using my Plustek 8200 and view on screen at 100%, the images are soft, lack contrast and grain, and difficult to determine where the focus point is. I enjoy the process and images alot, but am missing a alot in terms of sharpness. I have had decent results printing (digital) up to 8 x 11 inches but am not confident in going any further. The negs. are moderately physically flat and I scan the images at 3600 dpi with everything in Sivlerfast 8 turned off. The TIFF image is then imported into LR5 where sharpness can be improved very slightly. I have noticed I am able to bring a decent amount out of the shadows. My thoughts are... 1. Camera Shake- The travel on my M6 shutter release is a little further than what I'm used to 2. Underdevelopment- Its winter in Sydney and I think the temp might be dropping during development 3. Water is hard in Sydney and I will have to use Distilled water 4. Plustek is sitting on a soft coffee table and shake is causing the problem 5. Plustek is out of focus... I really hope not 6. Leica M6 isnt focusing on anything... I really really hope not I will have to revisit my work with trial and error, eliminating each of the above, but am sure there are some areas I am unaware of which you may be able to point out. Many thanks in advance!!
- 20 replies
-
- blurry film
- film development
-
(and 2 more)
Tagged with: