omllr Posted August 9, 2016 Share #1 Posted August 9, 2016 Advertisement (gone after registration) Hi, I want to replace the red dot on my M6 TTL, and I bought a black one from DAG. The problem is that I can't get the red logo off. DAG writes: Remove paper backing to expose adhesive on back side. To remove red Leica Logo, hold onto the word LEICA with your fingernails, twist left & right until the Logo comes off. Takes about 30 seconds of twisting to remove. This does not work for me. I hold for a long time, but it does not come off. Is there with anything else I can warm it up?. Thanks in advance. Link to post Share on other sites More sharing options...
Advertisement Posted August 9, 2016 Posted August 9, 2016 Hi omllr, Take a look here Want to gange the red dot on my M6 TTL. I'm sure you'll find what you were looking for!
spydrxx Posted August 9, 2016 Share #2 Posted August 9, 2016 You could try a hair dryer on low setting to warm it up. Link to post Share on other sites More sharing options...
Ernstk Posted August 10, 2016 Share #3 Posted August 10, 2016 You can also push on the red dot with Blu Tack and twist as you do so... Ernst Link to post Share on other sites More sharing options...
Stealth3kpl Posted August 10, 2016 Share #4 Posted August 10, 2016 I pushed to rotate clockwise then anticlockwise then clockwise etc using two matchsticks. I like the hairdryer idea. Pete Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.