Leitz Pradovit Colorplan 250 Autofocus - troubleshooting

[FredR]

Advertisement (gone after registration)

My Leitz Pradovit Colorplan 250 Autofocus projector all too often will not pull a slide from the tray into the projector, requiring me to return to the projector and push the mechanism and slide a few millimeters before the machine pulls the slide in.  Typically this will happen repeatedly.  I've looked at the trays and the "slide transport arm" (No. 9 in the photo), and I'm tempted to take a file and start modifying the latter.  But I know it's probably just an adjustment - somewhere.  The original instruction booklet does not address the issue.

 

Has anyone prior similar experience who can advise me, or point me to a webpage or video with troubleshooting advice for this projector?  I've been unable to find the solution through searching the internet.

 

Thanks in advance for your help!

 

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

Edited August 28, 2018 by FredR

[TomB_tx]

I think I remember having to replace a drive belt inside that had stretched. That was some years back, and did get the projector working, but the autofocus would never lock on. I found a Leitz tech bulletin about repairing autofocus by changing components on a circuit board, but never got around to trying it.

[FredR]

I think I remember having to replace a drive belt inside that had stretched. That was some years back, and did get the projector working...

 

That's good to hear, because I ordered a belt last week from Van Eck in Tilburg, Netherlands.  I hope the replacement procedure will be obvious, because Van Eck only has Dutch and German service manuals, neither of which I read.  I replaced both switches (power and bulb) which was a real PITA, but it was a success, so I think I can handle it.

Edited September 5, 2018 by FredR