@bumac Posted June 26, 2007 Share #1 Posted June 26, 2007 Advertisement (gone after registration) Anybody knows, where to find a pattern to manipulate a bayonet and codify it later? Link to post Share on other sites More sharing options...
Advertisement Posted June 26, 2007 Posted June 26, 2007 Hi @bumac, Take a look here Pattern 6-Bit Code M8. I'm sure you'll find what you were looking for!
EricC Posted June 26, 2007 Share #2 Posted June 26, 2007 Anybody knows, where to find a pattern to manipulate a bayonet and codify it later? Reiner, Is this what you are looking for? http://www.digital-leica.com/lens_codes/template.jpg Regards Eric Link to post Share on other sites More sharing options...
@bumac Posted June 26, 2007 Author Share #3 Posted June 26, 2007 Yes but no. I am loooking for a template to mill the bayonet. So I will need the exact degrees of the bit-marcs. Link to post Share on other sites More sharing options...
Hans Roggen Posted June 26, 2007 Share #4 Posted June 26, 2007 I have seen one or two around, but they were a bit offf, so i wouldn't advise using any template you find unless you were completely sure it's a good one. Hans Link to post Share on other sites More sharing options...
jaapv Posted June 26, 2007 Share #5 Posted June 26, 2007 I gave my machine shop a coded lens to use as a pattern. Link to post Share on other sites More sharing options...
robsteve Posted June 26, 2007 Share #6 Posted June 26, 2007 Anybody knows, where to find a pattern to manipulate a bayonet and codify it later? JLM posted a PDF of the milling specs a few months ago. It had what you wanted. The PDF is attached to John Milch's post in the thread linked below, permalink 44. http://www.l-camera-forum.com/leica-forum/digital-forum/13272-self-coded-35mm-summicron-m-asph-3.html Robert Link to post Share on other sites More sharing options...
@bumac Posted June 26, 2007 Author Share #7 Posted June 26, 2007 Advertisement (gone after registration) Thank you. It is really what I'm looking for. rw Link to post Share on other sites More sharing options...
jaapv Posted June 26, 2007 Share #8 Posted June 26, 2007 I think the link to the PDF is dead........ Link to post Share on other sites More sharing options...
Shootist Posted June 26, 2007 Share #9 Posted June 26, 2007 I think the link to the PDF is dead........ I just downloaded it from that link in the other thread. So it's not dead. Link to post Share on other sites More sharing options...
@bumac Posted June 26, 2007 Author Share #10 Posted June 26, 2007 ... it works..... Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.