lpig Posted February 8, 2013 Share #1 Posted February 8, 2013 Advertisement (gone after registration) Good morning to the Forum. The foam pad that is necessary to mainain in close contact my M6 camera and the base of its Leica Handgrip M (code 14405) needs to be replaced. I was looking for a precut pad, original or not, but without success. So, any idea of what kind of self-adhesive material? Regards. Marcello Link to post Share on other sites More sharing options...
Advertisement Posted February 8, 2013 Posted February 8, 2013 Hi lpig, Take a look here Foam pad, handgrip M (14405). I'm sure you'll find what you were looking for!
250swb Posted February 8, 2013 Share #2 Posted February 8, 2013 It is the same sort of rubber/neoprene material that you can buy in sheets for replacing light seals on cameras, so perhaps look on Ebay for light seal kits etc. This sort of thing 1.5mm CLOSED CELL FOAM LIGHT SEAL SELF ADHESIVE | eBay Steve Link to post Share on other sites More sharing options...
tobey bilek Posted February 12, 2013 Share #3 Posted February 12, 2013 Micro tools .com if you do not like EBay. Comes in 1,2, & 3 mm thickness. Or cut some black felt to shape and make the problem go away forever. Plyobond cement. The foam always goes bad and should be banned from use in camera light seals. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.