Stan Raucher Posted November 2, 2006 Share #1 Posted November 2, 2006 Advertisement (gone after registration) I think it might be useful to have a thread dedicated solely to suggestions to Leica for firmware upgrades based on the experience of people who have used an M8, either as a lucky owner or as someone who has had an opportunity to try one out at a demo. Thanks, Stan Link to post Share on other sites More sharing options...
Advertisement Posted November 2, 2006 Posted November 2, 2006 Hi Stan Raucher, Take a look here Firmware upgrade suggestions. I'm sure you'll find what you were looking for!
Stan Raucher Posted November 2, 2006 Author Share #2 Posted November 2, 2006 I posted this in another thread, but I'm afraid it might get lost in the noise, so I'll be the first to contribute to this thread. I would like to suggest the following ISO firmware change to Leica. When increasing the ISO values with the down arrow button, I would like the the ISO value to stop at 2500 and not roll over to 160. When decreasing the ISO value with the up arrow button, I would like the the ISO value to stop at 160 and not roll over to 2500. This way you could easily change the ISO value without looking at the back of the camera. For example, if you didn't remember what ISO you had set but wanted ISO 160, you could push the set button to get into the ISO menu (assuming that was the last setting you viewed or changed), and then push the up arrow four times. Regardless of what your inital ISO setting was, you would have scrolled and stopped at ISO 160. Press the set button again, and ISO 160 would be entered. Or press the down arrow button once, then press set and you would be at ISO 320. Obviously you could use this approach to set other ISO values as well. All with no peeking. Cheers, Stan Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.