DrJohnGreg Posted September 30, 2008 Share #1 Posted September 30, 2008 Advertisement (gone after registration) I have 4 of these old beasts, 2 Pradovit Color 2 & 2 P2002 which I use for shows with a fader/changer unit. One of the Color 2s has a problem and I need some info. I have repaired them before, they get a bit of a hammering, usually mechanical problems with some of the 'flimsy' plastic parts breaking inside, but this time it is a electrical fault. Some of the wiring on the circuit board which controls the fading and changing has come adrift (dry joints from the factory!) and I don't know which pins the loose wires should to be resoldered onto. Does anyone know where I can get a wiring diagram or similar? Or could someone with one of these projectors take their top off (if you see what I mean) and take a few pictures of the wiring? Link to post Share on other sites More sharing options...
Advertisement Posted September 30, 2008 Posted September 30, 2008 Hi DrJohnGreg, Take a look here Pradovit Color 2 projector help needed . I'm sure you'll find what you were looking for!
jpattison Posted September 30, 2008 Share #2 Posted September 30, 2008 Could you not just open the second Color 2, and compare? This way you can trace cables to a commom source, even if they used different colours (unlikely, but possible, especially if one has been repaired at any time) John Link to post Share on other sites More sharing options...
JohnGregory Posted September 30, 2008 Share #3 Posted September 30, 2008 Unfortunately they are not the same inside. There must have been production changes within the run of the model. The circuit boards look the same, superficially, but the wiring runs are subtally different. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.