NZDavid Posted May 12, 2011 Share #1 Â Posted May 12, 2011 Advertisement (gone after registration) I just turned on my X1 and it comes up with a pink screen, or half black and half pink. The shutter stays locked on 2000 no matter what the setting. I turned it off and on, took the battery out, took the card out, reformatted the card -- same result. Â The camera is recently back from Solms after a two and half month trip to clean the sensor. I have installed firmware 2.0 and have only used it once since getting it back. The camera has just under a year's warranty left. Link to post Share on other sites More sharing options...
Advertisement Posted May 12, 2011 Posted May 12, 2011 Hi NZDavid, Take a look here X1 error - help!!!. I'm sure you'll find what you were looking for!
nic Posted May 12, 2011 Share #2 Â Posted May 12, 2011 try an other SD-Card Link to post Share on other sites More sharing options...
NZDavid Posted May 12, 2011 Author Share #3 Â Posted May 12, 2011 Thanks, will do! That may fix it (fingers crossed). Just charging the battery. Standby and I'll report back. Link to post Share on other sites More sharing options...
Michail Posted May 12, 2011 Share #4 Â Posted May 12, 2011 Try it yourself once again install the firmware 2.0. Good luck! Link to post Share on other sites More sharing options...
NZDavid Posted May 12, 2011 Author Share #5 Â Posted May 12, 2011 No joy with new SD card. Guess I could reinstall firmware but I'm not optimistic. It was working fine before. Into the dealers tomorrow. Very disappointing. Link to post Share on other sites More sharing options...
NZDavid Posted May 15, 2011 Author Share #6 Â Posted May 15, 2011 Definitely sensor failure after receiving camera back from servicing. Only used it once. It's on its way. Will report back later -- which may be some time. Link to post Share on other sites More sharing options...
robert blu Posted May 17, 2011 Share #7 Â Posted May 17, 2011 Advertisement (gone after registration) Sorry for your bad luck! It's frightening! robert, still satisified user of x1... Link to post Share on other sites More sharing options...
wda Posted May 17, 2011 Share #8 Â Posted May 17, 2011 David, that is unfortunate. I have not read of this fault before. Do keep us posted. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.