Jump to content

Just bought an X1; have a question


symmetron

Recommended Posts

Advertisement (gone after registration)

Just got it today after almost buying an M8. Previously owned and sold M6 and MP and now I remember why; just couldn't get used to the RF.

 

Anyway, I noticed on the X1 that when focusing using AF mode, the camera makes some noise when trying to focus. Same when using it in MF mode when adjusting the focus point. Is that normal?

Link to post
Share on other sites

Completely normal and the green LED by the hotshoe should illuminate to show the camera has focussed , but i know what you mean as the X1 tends to make more noise and its body vibrates slightly more than other digital cameras i have used when focussing.

 

Brian

Link to post
Share on other sites

  • 2 weeks later...

hi guys, i also got an x1 recently. Still doesn't know my way around x1.

 

I was reading the manual with regard to 1 point and spot mode. It says in the manual: Use the direction buttons to move AF frame to the desired position. I tried clicking the direction buttons, however the AF frame remains in the middle.

 

Firmware is upgraded to 2.0

 

Thanks.

Link to post
Share on other sites

Hi, hold the2nd Button on the Left-> DOWN for 2 seconds.. then the Focus on the screen will have 4 red arrows .. use the control wheel to move the Focus...

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...