scott kirkpatrick Posted December 31, 2020 Share #1 Posted December 31, 2020 Advertisement (gone after registration) Surprise! After connecting to my SL2-S with Fotos, I put the camera into multishot mode and selected a delay of 2 sec before the shot. Then I went into Remote, focused and pressed the trigger on my phone. The results was a multishot, followed by a single exposure, just as it works on the camera. I tried to also get a bracket (you can set that using settings > Drive > bracket), but nothing happened. Just a single shot and the camera was left in single shot. I finally connected to my SL2 and tried the multishot experiment, but that did not work. One shot resulted and it left the camera in single shot mode. So the change is in camera firmware, not in Fotos. Obvious experiment for another day is to set up a bracket on the camera, fixing all the parameters that you have to choose one or more levels down in the menus. Then see if it will launch from Fotos. T 2 Quote Link to post Share on other sites More sharing options...
Advertisement Posted December 31, 2020 Posted December 31, 2020 Hi scott kirkpatrick, Take a look here Multishot works with Fotos and SL2-S. I'm sure you'll find what you were looking for!
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.