otto.f Posted October 15, 2016 Share #1 Posted October 15, 2016 Advertisement (gone after registration) When I import Monochrome-1 files into Capture the sharpness is default set on a value 180, which is way too sharp (for the normal M9 this is 130 btw, which can be too sharp too). Does someone know how I can change this value automatically to 0 whenever I import from a specified camera? I would really like to see how the lens draws and not the software Quote Link to post Share on other sites More sharing options...
Advertisement Posted October 15, 2016 Posted October 15, 2016 Hi otto.f, Take a look here Question: Change default sharpness MM1 in CaptureOne?. I'm sure you'll find what you were looking for!
Giulio Zanni Posted October 15, 2016 Share #2 Posted October 15, 2016 All softwares to some degree apply some sharpening to the raw files, which is intended as pre-sharpening. I would not set it to 0, I would just lower the level if you deem that is excessive 1 Quote Link to post Share on other sites More sharing options...
Steve Ash Posted October 16, 2016 Share #3 Posted October 16, 2016 Go to the sharpening tool, adjust the values as you like, click on the three little dots, save as defaults for your camera. Gesendet von iPhone mit Tapatalk 2 Quote Link to post Share on other sites More sharing options...
indergaard Posted November 7, 2016 Share #4 Posted November 7, 2016 Go to the sharpening tool, adjust the values as you like, click on the three little dots, save as defaults for your camera. Gesendet von iPhone mit Tapatalk I would also do the same with the default Noise Reduction settings, which are also very aggressive at the default value of 50 ... Not really needed on the MM. Quote Link to post Share on other sites More sharing options...
otto.f Posted November 7, 2016 Author Share #5 Posted November 7, 2016 Thank you! Quote Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.