Recently Browsing 0 members
No registered users viewing this page.
For unknown reason(s) an oddity is happening with indicated exposure times seen in viewfinder. After making an exposure, for the next two exposures there is no variation in indicated exposure time when panning about with camera. After the third exposure, the indication again varies properly as you pan about different scenes. Then repeats. As if there were an unwanted exposure lock mode in effect for 2nd and 3rd shot of a 3 shot sequence..
Cannot find any obvious settings error likely to be the cause. The bracketing is set to 0.
Tried to reload latest firmware but it "completes" in about two seconds so never happened. Does Leica determine the actual present checksum of the loaded firmware and decide that a reload is not necessary??
What am I missing here? Thanks.
Apologies if this topic is already in the system by me, but for some reason I could not find what I had posted.
Anyway the issue I seem to be having since updating the firmware to v2.0 is that I have had a couple of crashes, or my camera locking up. The on/off button does nothing, the OLED display and LCD are still on. The only remedy to reset is to remove the battery. So far its happened 3 times. Anybody else experiencing this?
I wonder if anyone else if experiencing the SL2 freezing, no response, even if I switch off the OLED display and LCD panel still show information. This only seems to have happened after I updated to the latest firmware V2.0. The only action is to remove the battery and then start again. This has happened 2-3 times in the last week or so. So not immediately after the update, which is slightly more concerning.
I'm looking for a battery for a Digilux 3. I can't seem to find one. Would anyone know of a place in the U.S. that might have one
I have this list of compatible model numbers, often leading to questionable websites
BP-DC1, BP-DC3, BP-DC3 E, BP-DC3 J, BP-DC3 U
CGR-S602, CGR-S602A, CGR-S602A/1B, CGR-S602E/1B, CGR-S602SE, CGR-S603A/1B, DMW-BL14